How to install led vehicle safety flashing lights

In different applications, the installation of LED vehicle safety flashing lights is a bit different, but if you know the principle, you can install it correctly.

Please pay attention when installing LED vehicle safety flashing lights. The LED vehicle safety flashing lights are divided into positive and negative poles. The red wire is the positive pole and the black wire is the negative pole. The positive pole is connected to the port and the negative pole is connected to the screw, otherwise, it will not flash.

Be sure to pay attention to the operation when installing the LED emergency warning lights, because the space is small, take your time and don't worry.

Normal wiring method: connect the screw at one end, connect the broken wire port at the other end, and then cross-connect the cable to make it flicker normally.

In addition, a switch can be installed as an option.

The above is an introduction to the installation methods of some LED vehicle safety flashing lights. There are also many ways to fix the LED vehicle safety flashing lights. Some are magnets and can be directly attached to the car, and some are screw-fixed and can be installed on many occasions.